|
Tramex Roof & Wall Moisture Scanner is used for
non-destructive moisture evaluation of Roofs and EIFS Building Envelope |
Features & Applications:
The RWS incorporates two of Tramex's well-known moisture scanners, the
Leak Seeker for Roofing, and the Wet Wall Detector for EIFS, incorporating
all the benefits and features of both these time proven instruments into
this one instrument.
The Tramex RWS has dual operating modes for EIFS and Roofing. Each of
these modes has 2 ranges of sensitivity for both deep and low penetration
sensitivity, enabling the scanning of Roofing, and EIFS, with a signal
penetration ranging from the surface up to approximately 4" (100mm).
Features:
-
For tracing leaks into the waterproofing membrane back to the source
-
Fast and easy to operate
-
Instant clear readings
-
“Hold” function facilitates ease of recording readings
-
Lightweight hand held and battery operated
Applications:
Multi-mode moisture scanner for non-destructive moisture detection and
leak tracing in the building envelope including:
-
Built-Up
-
Non-Conductive Single Ply
-
Modified and Foamed Roofing Systems
-
Exterior Insulation and Finishing Systems (EIFS)
Spec Summary:
|
Dimensions:
|
4.75”x 11” x 3”/ 125mm x 275mm
x 75mm
|
|
Weight:
|
1.8kg (4lbs)
|
|
Power Supply:
|
One 9 volt battery
|
|
Sensitivity:
|
Four ranges:
EIFS Mode with high and low sensitivity.
Roofing Mode with high and low sensitivity.
|
|
Accessories:
|
Leather carrying case. Telescopic
handle for use on roofing only.
|
|
Limitations:
|
Roofing: EPDM, Butyl rubber roofing
and
other conductive roofing.
EIFS: Hard Coat Stucco, wire lath or
wire mesh reinforced finishes.
|
Copyright © E.L.Hilts & Company
. All rights reserved.
Revised: January 04, 2008.
|
